Humminbird SOLIX Series Operation Manual page 212

Display Range Markers
To mark a specific range on the view, turn on Range Marker. This
menu is available in Custom Mode (see The Menu System: Change
the User Mode).
1. With a Side Imaging View displayed on-screen, tap Sonar (SI)
in the status bar, or press the MENU key once.
2. Select Sonar Options > Range Marker.
3. Select Left Marker or Right Marker.
4. Tap the on/off button, or press the ENTER key, to turn it on.
5. Press and hold the slider, or press and hold the ENTER key, to
adjust the setting.
Select Frequencies
If there are multiple beams available in a transducer, you can display individual frequencies on the view. See Installation Information:
Set up your Humminbird Network, Select Sonar Sources and Set up or Change Transducer Settings for details.
1. With a Side Imaging View displayed on-screen, tap the frequency menu in the status bar.
OR
Press the MENU key. Select SI Frequency Select.
2. Select a frequency from the list.
NOTE: If the control head is using a sonar source with only one beam frequency, the frequency list will not offer additional options.
QUICK TIP! This setting can also be changed by pressing and holding the ENTER key.
Adjust the SI Sensitivity Offset
In the unlikely event that your Side Imaging transducers are not
tuned to the same level, you can offset the left Side Imaging beam
from the right Side Imaging beam.
1. With a Side Imaging View displayed on-screen, tap Sonar (SI)
in the status bar, or press the MENU key once.
2. Select Sonar Options.
3. Select SI Sensitivity Offset.
4. Press and hold the slider, or turn the Rotary dial, to adjust the
setting.
Side Imaging
Adjusting the SI Sensitivity Offset
212
range markers