Humminbird SOLIX Series Operation Manual page 20

3
| Start Radar Transmission
For more information about Humminbird CHIRP Radar and Humminbird Radar, see Radar Overview.
WARNING! The radar should be configured by a qualified radar technician after installation or equipment repair. See Installation
Information: Configure Humminbird Radar.
1. Confirm the radar power source is turned on (breaker or switch).
2. Press the POWER key.
3. Humminbird CHIRP Radar: Select Radar > Standby. Press the POWER key again, and select Radar > Transmit.
Humminbird Radar: Select Radar Transmit. Tap the on/off button, or press the ENTER key, to turn it on.
4
| Pair a Bluetooth supported Mobile Device with the Control Head
Use the following instructions to pair a mobile device (phone or tablet) to the control head using Bluetooth wireless technology.
NOTE: If you have a Bluetooth Talon or the Bluetooth Wireless Remote (separate purchases required), see the accessory
operations manual for each product for pairing instructions. Operations manuals can be downloaded from our Web site at
humminbird.com.
NOTE: WiFi or cellular data must be enabled on your device.
Enable Bluetooth on your Device
1. Open the Settings menu on your device.
2. Select Bluetooth.
3. Select On.
Pair the Phone with the Control Head
1. Press the HOME key.
2. Select the Bluetooth tool.
3. Select Connect Phone.
4. Under Device List, select your phone name.
It may take a moment for your phone name to appear in the menu.
5. Follow the on-screen prompts to complete the pairing process.
6. Check your phone. When prompted, tap Pair on your phone.
7. In your phone Settings menu, turn on Show Notifications.
8. Turn Connection On/Off: Under Phone, select your phone name and tap the on/off button.
Forget Device: To remove the paired device, select Forget Device.
Getting Started
(connected Radar source required)
20