Table of Contents
Advertisement
Service and maintenance
8.1 Removing material accumulation
1. Remove any material build-up from the top of the calibration weights.
2. Remove any material build-up from the top surface of the calibration weight supports
between the calibration weights and the conveyor scale.
3. Check inside the MWL crank body and inspect the threaded shaft drive: if material has
accumulated here, remove it with an air stream or other suitable device.
Note
The threaded shaft and guide plates are normally not accessible to the human hand: do
not force any foreign matter into the area during operation.
42
Milltronics MWL Weight Lifter
Operating Instructions, 11/2011, 7ML19985CR03-03
Advertisement
Table of Contents
