Mount Crank Bodies - Siemens Milltronics MWL Weight Lifter Operating Instructions Manual

4.2.2

Mount crank bodies

1. Refer to the shim thickness tables (Page 24) to determine whether you need to shim the
MWL; shimming is not always required.
2. If necessary, select and position the appropriate size shim(s).
3. Loosely mount each crank body to the conveyor stringers using 12 mm (1/2") bolts, nuts, and
washers.
①
②
③
④
⑤
⑥
⑦
Note
The crank bodies must be left loose to allow for the torque shaft installation.
Milltronics MWL Weight Lifter
Operating Instructions, 11/2011, 7ML19985CR03-03
locking ball-pin tethered to crank body
crank body
input shaft
shim (if required)
bolt
washer
nut
Installing/Mounting
4.2 Installation procedure
15