Table of Contents
Advertisement
Operation
7.1 Operation (manual version)
Storing calibration weights
After you have completed the scale calibration procedure, turn the crank handle until the lifting
arms are fully raised.
①
②
Storing crank handle
Remove the crank handle and store it to prevent it from impeding traffic or material when the
conveyor is in operation.
1. Remove the locking ball-pin tethered to the crank handle, and remove the handle.
2. Use the locking ball-pin tethered to the crank body nearest to the handle to secure the MWL
from unintended use and to store the crank handle.
3. Insert the locking ball-pin through the hole in the crank handle, and into the insertion point in
the center of the crank body. Two clips on the side of the crank body help to hold the handle
in position.
4. Cover the input shafts with a guard if they present a hazard to personnel when the MWL is
not in use.
38
crank handle stored on far side of crank body, with locking ball-pin
lifting arms raised
Milltronics MWL Weight Lifter
Operating Instructions, 11/2011, 7ML19985CR03-03
Advertisement
Table of Contents
