Siemens Milltronics MWL Weight Lifter Operating Instructions Manual page 23

3. Ensure there is 10 mm (0.38") minimum clearance between the underside of the base-bar
weight and the top of the lowered MWL lifting arms. If necessary, shim the belt scale and
adjacent idlers to achieve this clearance.
①
②
③
④
4. Gently turn the crank handle, or use the control buttons, until the lifting arms are fully raised:
you may need to guide the notches in the base-bar weight in line with the lifting arms initially.
①
Milltronics MWL Weight Lifter
Operating Instructions, 11/2011, 7ML19985CR03-03
calibration weight support
10 mm (0.38") minimum gap
lifting arm lowered
underside of base-bar weight
lifting arm engages the notch on the end of the base-bar weight
Installing/Mounting
4.2 Installation procedure
21