Siemens SIMATIC ET 200SP HA System Manual page 72

Installation
5.6 Installing the terminal block
Procedure
To install these modules, proceed as follows:
(installation always from left to right)
Step
1
2
You can find information on wiring in following sections:
● Wiring rules (Page 85)
● Wiring the terminal block (Page 86)
72
Procedure
Slide the terminal block diagonally into the holder of the
carrier module.
Swivel the terminal block downwards until the fastening
elements on the carrier module click into place.
(See figure "Fastening the terminal block")
Illustration
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD