Ce Marking - Siemens SIMATIC ET 200SP HA System Manual

Technical specifications
9.1 Standards and approvals
Safety information
Personal injury and damage to property may occur
Note the following information for use in hazardous areas:
● Personal injury and property damage can be incurred if the ET 200SP HA connectors are
● In hazardous areas, always ensure that power to the ET 200SP HA is turned off before
Explosion hazard
If you replace components, compliance with Class I, DIV 2 can become invalid.
Area of application
This device is only suitable for use in Class I, Div. 2, Group A, B, C, D, or in non-hazardous
areas.
9.1.2

CE marking

Introduction
The ET 200SP HA distributed I/O system meets the requirements and protective objectives of
the following EC directives, and satisfies the Harmonized European Standards (EN) for
Programmable Logic Controllers which were published in the official pamphlets of the
European Community:
● Low voltage directive
● EMC directive
● Explosion protection directive
You can find the EC declarations of conformity for download on the Internet (keyword
"Declaration of conformity").
Low voltage directive
2014/35/EU "Electrical equipment designed for use within certain voltage limits" (Low Voltage
Directive)
According to the requirements of EN 61010-2-201, the components of the distributed I/O
system ET 200SP HA have been tested in compliance with the low voltage directive.
134
WARNING
pulled out during operation or if the output disable switch is pressed.
removing the plug connections or pressing the output disable switch.
WARNING
WARNING
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD