Declaration Of Conformity - Control Techniques Unidrive 1 Series User Manual

Control Techniques Ltd
The Gro
Newtown
Powys
UK
SY16 3BE
UNI1201 UNI1202 UNI1203
UNI2201 UNI2202 UNI2203
UNI3201 UNI3202 UNI3203
UNI1401 UNI1402 UNI1403
UNI2401 UNI2402 UNI2403
UNI3401 UNI3402 UNI3403
UNI4401 UNI4402 UNI4403
UNI5401
The AC variable speed drive products listed above, including the VTC,
LFT (all sizes) and REGEN (UNI3401 to UNI4405 only) variants, have
been designed and manufactured in accordance with the following
European harmonised, national and international standards:
EN 60249 Base materials for printed circuits
Printed boards: general information for the
IEC326-1
specification writer
Printed boards: specification for single- and double-
IEC326-5
sided printed boards with plated-through holes
Printed boards: specification for multilayer printed
IEC326-6
boards
Insulation co-ordination for equipment within low-
IEC664-1
voltage systems: principles, requirements and tests
Degrees of protection provided by enclosures (IP
EN 60529
code)
UL94 Flammability rating of plastic materials
UL508C Standard for power conversion equipment
Generic emission standard for the residential,
1
EN 50081-1
commercial and light industrial environment
Generic emission standard for the industrial
EN 50081-2
environment
Generic immunity standard for the industrial
EN 50082-2
environment
Adjustable speed electrical power drive systems - Part
EN 61800-3 3: EMC product standard including specific test
methods
1
Conducted emission sizes 1 to 3, not size 4 or 5. See the relevant EMC
Data Sheet.
6

Declaration of Conformity

UNI1204 UNI1205
UNI3204
UNI1404 UNI1405
UNI3404 UNI3405
UNI4404 UNI4405
www.controltechniques.com
These products comply with the Low Voltage Directive 73/23/EEC, the
Electromagnetic Compatibility (EMC) Directive 89/336/EEC and the CE
Marking Directive 93/68/EEC.
W. Drury
Executive Vice President, Technology
Newtown
Date: 26 September 2001
These electronic drive products are intended to be used with
appropriate motors, controllers, electrical protection components
and other equipment to form complete end products or systems.
Compliance with safety and EMC regulations depends upon
installing and configuring drives correctly, including using the
specified input filters. The drives must be installed only by
professional assemblers who are familiar with requirements for
safety and EMC. The assembler is responsible for ensuring that the
end product or system complies with all the relevant laws in the
country where it is to be used. A Unidrive EMC Data Sheet is also
available giving detailed EMC information.
Unidrive User Guide
Issue Number: 9