Unpacking And Installation - Canon LBP-CX Series Service Manual

II. UNPACKING AND INSTALLATION
The EP cartridge
is
not packed with the printer; be sure to take an EP cartridge with you when you plan to
install a printer.
No Procedure Checkpoint Remarks
1
Open the cardboard box. See Fig. 5-2.
2
Remove the parts and literature from
Check that the following are present:
the depressions in the foam packing •print tray
sheet. •manual feed tray
•cassette
3
Lift off the foam packing and remove
the printer in its sealed bag.
4
Remove the aluminum bag from
Check for damage to the exterior
around the printer. Remove the tape during transportation.
securing components.
5
Lift the release grip, and raise the Check that the inside is not dirty.
upper half of the printer. If dirty clean it with damp cloth.
6
Open the top cover of the fixing See Fig. 5-3.
assembly and remove the two spacers.
7
Take the fixing roller cleaner felt out
of the package. Insert it securely into
the groove in the top part of the
fixing assembly. Then lower the top
of the fixing assembly back into place.
8
Peel off the tape securing the wire
See Fig. 5-4.
cleaner,
9 If the printer is being installed where
line voltage is l l 5V.
10
Remove the power switch cover. See Fig. 5-5.
11
Check to make sure that the setting
See Fig. 5-5.
of the voltage selector (the selector
is on the side with the screw) matches
the power supply voltage (220/240V).
If so, replace the cover and skip to
step 13.
12 If the voltage setting is not correct,
See Fig. 5-5.
remove the screw securing the
selector, and rotate the selector 90°
to match the setting with the power
supply voltage. If the printer is to be
set for 240V, replace the 220V rating
plate with the 240V rating plate that
is
inside the power switch cover.
Resecure the selector, and replace
the cover.
5-2
COPYRIGHT
©
BY CANON INC. CANON LBP·CX SERIES REV .2 JULY 1985 PRINTED IN JAPAN (IMPRIME AU JAPONI