Externals; Covers And Panels; Top Cover; Right And Left Panels - Canon LBP-CX Series Service Manual

I.
EXTERNALS
A. Covers and Panels
2
Figure 4-1
1. Front panel 5. Rear panel
2. Print tray 6. Manual feed tray
3. Left panel 7. Right panel
4. Top cover 8. Right door
Note:
If not at the beginning of a line, numbers inside
parentheses() refer to the number of screws that must
be removed to detach a part. When cleaning inside the
printer, inspecting or repairing, remove the necessary
panels as explained. Because the panels are removed
and attached just by loosening or removing screws,
the procedure is not detailed.
1.
Rear
panel
(1)
Open the printer (raise the upper half) and the
right door.
(2) Take out the EP cartridge.
(3) Remove the four fastening screws to remove the
rear panel.
Figure 4-2
2. Top cover
( l) Open the printer (raise the upper half) and the
right door.
(2) Take out the EP cartridge.
(3) Take off the rear panel.
( 4) Remove the four fastening screws for the top
cover.
(5) Lift the right side of the top cover and remove
the connectors from the DC supply for the video
controller, DC controller, and the interface con-
nector. Remove the top cover.
Figure 4-3
3. Right and left panels
(1)
Open the printer (raise the upper half) and open
the right door.
(2) Take out the EP cartridge.
(3) Take off the rear pa9el and top cover.
(4) Take off the left and right panels (2
+
4 = 6).
Figure 4-4
COPYRIGHT
©
BY CAllON lllC. CANOll LBP.f:X SERIES REY.2 JULY 1985 PRlllTm IN JAPAN (IMPRIME AU JAPONJ
4-1