It is recommended that the serviceman personally
the customer's premises before installing any
printer. The location should meet the following
The line voltage should not vary more than ±10%
from the voltage marked on the printer nameplate,
and a ground connection should be available.
The temperature should be between l 0° to 3 2. 5° C
(50° -90.5°F), and the relative humidity 20 to 80%.
The printer should not be installed near water
faucets, boilers, humidifiers, refrigerators, etc.,
and should not be put in a location where the
temperature changes abruptly, such as near
The printer should not be exposed to open flames,
dust, ammonia fumes, or direct sunlight. (A heavy
curtain can be installed to protect the printer if it
must be placed in a sunny location).
The room should be well-ventilated.
More than 11 Ocm
The printer should be installed on a sturdy, level
Figure 5-1 Installation space requirements
The printer should be located at least 17.5 cm (7")
from the rear wall. There should be sufficient
space to permit unimpeded operation.
BY CANON INC. CAllDll LBP·CX SERIES HEY.2 JULY 1985 PRINTED IN JAPAN (IMPRIME AU JAPDNI