Transfer Guide - Canon LBP-CX Series Service Manual

2. Removal
(I),
Open the printer (raise the upper half).
(2) Take the EP cartridge out. Close the upper
half. Remove the rear panel, top cover, and left
panel. (See Figs. 4-2 to 4-5.)
(3) Unplug the connector, and the scanner and
laser unit. (See Fig. 4-60.)
(4) Remove the DC power supply and main motor
driver PCB together with the heat sink. (See Fig.
4-99.)
(5) Remove the connector and four Faston connec-
tors.
Figure4-33
( 6) Remove the two screws.
Figure4-34
(7) Open the printer and remove the registration
shutter.
Be careful of the following when assembling.
Q)
Place each grip ring on the shaft so that there
is a clearance of 0.2 ± 0.1 mm between the
ring and the lever or arm when each is pressed
firmly against its mount.
@
Attaching the guide spring
Guide
spring
Feed roller
shaft
C. Transfer Guide
l. Outline
0.2±0.1
mm
Grip ring
Lever .
0
Grip
ring
Figure 4-35
d
Upper guide plate
Figure4-36
0.2±0.1
mm
The transfer guides consist of plates and rollers
which guide the paper (manual or cassette feed)
to the transfer unit·of the photosensitive drum.
Lower transfer guide
Figure 4-37
COPYRIGHT
©
BY CANON INC. CANON LBP·CX SERIES REY.2 JULY 1985 PRINTED IN JAPAN (IMPRIME AU JAPDNJ
4-9