Introduction; Purpose Of The Manual; Additional Resources; Document And Software Version - Danfoss VLT AutomationDrive FC 360 Application Manual

Introduction

1 1
1 Introduction

1.1 Purpose of the Manual

This manual provides information on how to design and
implement center winder control and positioning control
applications with FC 360 frequency converters. It does not
cover general design, installation and commissioning of
the frequency converter.
®
VLT is a registered trademark.
Prerequisites
The manual is intended for use by qualified personnel who
are familiar with the functions of VLT
360 and have hands-on experience with installing and
commissioning FC 360 frequency converters. The
frequency converter should be installed and commissioned
according to the FC 360 Quick Guide. Users of this manual
should have the Quick Guide at hand for reference.

1.2 Additional Resources

Additional resources are available to understand frequency
converter functions and programming.
•
®
VLT
provides information required to install and
commission the frequency converter.
•
®
VLT
provides detailed information about the design
and applications of the frequency converter.
•
®
VLT
provides information on how to programme and
includes complete parameter descriptions.
Contact the local Danfoss supplier for the printed
documentation.

1.3 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
In the frequency converter, read the software version in
15-43 Software Version.
Version
MG06E1 First version of the document.
Table 1.1 Document and Software Version
2
®
AutomationDrive FC
AutomationDrive FC 360 Quick Guide,
AutomationDrive FC 360 Design Guide,
AutomationDrive FC 360 Programming Guide,
Remarks Software version
Danfoss A/S © 11/2014 All rights reserved.
®
VLT AutomationDrive FC 360

1.4 Abbreviations and Conventions

AC
AEO
ACP
AWG
AMA
°C
DC
EEPROM
EMC
EMI
ETR
f
M,N
FC
IP
I
LIM
I
INV
I
M,N
I
VLT,MAX
I
VLT,N
L
d
LCP
MCP
N.A.
P
M,N
PCB
PE
PELV
PWM
R
s
Regen
RPM
RFI
SCR
SMPS
T
LIM
U
M,N
X
h
Table 1.2 Abbreviations
Conventions
1.4x
•
•
•
Alternating current
Automatic energy optimisation
Application control processor
American wire gauge
Automatic motor adaptation
Degrees Celsius
Direct current
Electrically erasable programmable
read-only memory
Electromagnetic compatibility
Electromagnetic interference
Electronic thermal relay
Nominal motor frequency
Frequency converter
Ingress protection
Current limit
Rated inverter output current
Nominal motor current
Maximum output current
Rated output current supplied by the
frequency converter
d-axis inductance
Local control panel
Motor control processor
Not applicable
Nominal motor power
Printed circuit board
Protective earth
Protective extra low voltage
Pulse width modulated
Stator resistance
Regenerative terminals
Revolutions per minute
Radio frequency interference
Silicon controlled rectifier
Switch mode power supply
Torque limit
Nominal motor voltage
Main reactance
Numbered lists indicate procedures.
Bullet lists indicate other information.
Italicised text indicates
MG06E102