Removing Power Supply Units; Unpacking And Checking Package Contents - Avaya G450 Install Book

Before you install

Removing power supply units

For ease of installation and to enable single-person installation, it is recommended to remove
the power supply unit(s) before unpacking the G450.
1. Open the package. Note that the G450 is lying flat. Turn it so that the rear panel is facing
up.
2. Remove the power supply unit (PSU). If you ordered two PSUs, remove them both.
a. Loosen the two PSU captive screws, one on each side of the PSU.
b. Grasp the two side handles and pull the PSU up and out.
c. Place the PSU carefully on the table.

Unpacking and checking package contents

1. Unpack the G450 and accessories.
ELECTROSTATIC ALERT:
Wear an anti-static wrist ground strap whenever handling components of an
ELECTROSTATIC ALERT:
Avaya G450 Media Gateway. Connect the strap to an approved ground, such as
an unpainted metal surface.
2. Check the contents of the packaging against the customer order.
3. Cross-check the customer order with the planning documentation you have been given.
Media modules, telephones and other equipment are listed on your planning and shipping
documentation. Placement for the media modules and other equipment are also indicated.
4. Verify that all necessary elements have been received and are in good condition. If there
are missing or damaged elements, contact your project manager. The planning
documentation will list contact information for key personnel.
If you have any questions about the equipment order, or if the equipment has been damaged,
contact your project manager.
24 Installation and Upgrades for the Avaya G450 Media Gateway