Symbols On The Product - Husqvarna Automower 310 Operator's Manual

23. Loop wire for boundary loop and guide wire
1
24. Couplers for loop wire
3
25. Stakes
26. Connector for the loop wire
27. Screws for securing the charging station
28. Measurement gauge for help when installing
the boundary wire (the measurement gauge
is broken loose from the box)
29. Operator's Manual and Quick Guide
30. Cable markers
31. Extra blades
32. Low voltage cable
33. Alarm decal

1.4 Symbols on the product

These symbols can be found on the product.
Study them carefully.
1
Is a part of the Installation kit which is purchased separately.
2
Refer to note 1
3
Refer to note 1
4
Refer to note 1
1220 - 001 -
2
4
WARNING: Read the
user instructions before
operating the product.
WARNING: Operate the
disabling device before
working on or lifting the
machine.
The product can only start
when the main switch is
1 and the correct
set to
PIN code has been en-
tered. Turn the main
0 before carry-
switch to
ing out any inspections
and/or maintenance.
WARNING: Keep a safe
distance from the ma-
chine when operating.
Keep your hands and feet
away from the rotating
blades.
WARNING: Do not ride
on the machine. Never
put your hands or feet
close to or under the ma-
chine.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 53 and on the
rating plate.
Introduction - 5