Husqvarna Automower 310 Operator's Manual page 30

3.9.10.3 Spiral Cutting
The product cuts the grass in a spiral pattern if
the grass is longer in an area.
be set in 5 levels:
• Low-
• Low
• Mid
• High
• High+
The level sets how sensitive the product is to
changes in grass height.
Spiral cutting is only started in the Main
Note:
area mode. Cutting in the
does not let the product to start
Spiral Cutting does not start in slopes steeper
than 15%.
To set the level of Spiral Cutting
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Spiral Cutting > Use Spiral Cutting >
Intensity .
3. Use the left arrow button to select the level
of the Spiral Cutting.
4. Push the BACK button.
3.9.10.4 Slope control
In order to decrease lawn wear near the
boundary wire in slopes, the product prevents to
move in the opposite direction when the product
Slope control is enabled in
operates in a slope.
the factory settings.
To disable the Slope control
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Slope control > Use Slope control .
3. Push the BACK button.
3.9.10.5 To set the time & date
1. Do steps 1–3 in To get access to the menu
on page 23 .
30 - Installation
Spiral cutting can
Secondary area mode
Spiral cutting .
Settings >
Settings >
2. Use the arrow buttons and the OK button to
move through the menu structure
General > Time & Date .
3. Use the number buttons to set the time and
then push the BACK button.
4. Use the number buttons to set the date and
then push the BACK button.
5. Use the arrow buttons to set the time format
and then push the BACK button.
6. Use the arrow buttons to set the date format
and then push the BACK button.
3.9.10.6 To set the language
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
General > Language.
3. Use the arrow buttons to select language
and then push the BACK button.
3.9.10.7 To set the country
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
General > Country.
3. Use the arrow buttons to select country and
then push the BACK button.
3.9.10.8 To reset all user settings
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
General > Reset all user settings .
3. Use the right arrow button to select
with reset of all user settings?
4. Push the OK button to reset all the user
settings.
Security level, PIN code, Loop signal,
Note:
Messages, Date & Time, Language and Country
settings are not reset.
3.9.10.9 The About menu
About menu displays information about the
The
product, for example serial number and firmware
versions.
Settings >
Settings >
Settings >
Settings >
Proceed
1220 - 001 -