Husqvarna Automower 310 Operator's Manual page 19

0 cm / 0"
CAUTION: Do not put a section of
boundary wire across the other.
The sections of boundary wire
must be parallel.
CAUTION: Do not put the guide
wire across the boundary wire, for
example a boundary wire that
goes to an island.
3.3.3.4 To make a secondary area
Make a secondary area (B) if the work area has 2
areas that are not connected with a passage. The
work area with the charging station is the main
area (A).
Note: The product must be manually moved
between the main area and the secondary area.
1220 - 001 -
B
A
• Put the boundary wire around the secondary
area (B) to make an island. Refer to
make an island on page 18 .
Note: The boundary wire must be put as 1
loop around all of the work area (A + B).
Note: When the product cuts grass in the
secondary area, the
must be selected. Refer to
on page 34 .
3.3.3.5 To set the corridor width of the boundary
wire
The boundary wire corridor is the area adjacent
to the boundary wire, which the product uses to
find the charging station. When the product
moves in the direction of the charging station, it
always moves to the left of the boundary wire.
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Corridor width > Boundary.
3. Use the number buttons to select a corridor
width of 0 to 9.
4. Push the BACK button.
3.3.4 To examine where to put the guide
wire
• Put the guide wire in a line at a minimum of
2 m / 7 ft. in front of the charging station.
• Make sure that the guide wire has as much
free area as possible to the left of the guide
wire when facing the charging station. Refer
To
Secondary area mode
Secondary area
Installation
Installation - 19