Troubleshooting; Introduction - Troubleshooting; Fault Messages - Husqvarna Automower 310 Operator's Manual

6.1 Introduction - troubleshooting

In this chapter, a number of messages are listed which may be shown in the display if there is a
malfunction. There is a proposal as to the cause and steps to take for each message. This chapter also
presents some symptoms that can guide you if the product does not work as expected. More
suggestions for steps to take in the event of malfunction or symptoms can be found on
www.husqvarna.com.

6.2 Fault messages

Below a number of fault messages are listed which may be shown in the product display. Contact your
local Husqvarna representative if the same message appears often.
Message Cause
Wheel motor
Grass or other object has wrapped
blocked, left
around the drive wheel.
Wheel motor
Grass or other object has wrapped
blocked, right
around the drive wheel.
Cutting system
Grass or other object has wrapped
blocked around the blade disc.
The blade disc lies in a pool of water.
No loop signal
The power supply is not connected.
The low voltage cable is damaged or
not connected.
The boundary wire is not connected to
the charging station.
Boundary wire broken.
ECO mode is activated and the product
has attempted to start outside the
charging station.
1220 - 001 -

6 Troubleshooting

Action
Check the drive wheel and remove the
grass or other object.
Check the drive wheel and remove the
grass or other object.
Check the drive wheel and remove the
grass or other object.
Move the product and prevent the col-
lection of water in the work area.
Check the wall socket connection and
whether an earth-fault breaker has trip-
ped or not. Check that the low voltage
cable is connected to the charging sta-
tion.
Check that the low voltage cable is not
damaged. Check that it is also properly
connected to the charging station and
to the power supply.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Replace connectors if dam-
aged. Refer to
wire on page 21 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
nal coupler. Refer to
loop wire on page 49 .
Place the product in the charging sta-
tion, press the START button and close
the hatch. Refer to
29 .
To install the boundary
Find breaks in the
ECO mode on page
Troubleshooting - 41