Husqvarna Automower 310 Operator's Manual page 29

To get access to the menu
1. Do steps 1-3 in
on page 23 .
2. Use the arrow button and the OK button to
move through the menu structure
> Advanced > Reversing distance .
3. Use the number buttons to set the reverse
distance in cm.
4. Push the BACK button.
3.9.9 To set the Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting is 31 cm. You can select a
distance of 20-50 cm.
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow button and the OK button to
move through the menu structure
> Advanced > Drive Past Wire .
3. Use the number buttons to set the distance
in cm.
4. Push the BACK button.
3.9.10 Settings
In settings you can change the general settings
to your product.
3.9.10.1 Profiles
Different sets of product settings can be saved if
the product is used in different work areas with
different charging stations. You can set a
maximum of 3 profiles.
To save settings to a profile
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use profiles > Profile A, B, C.
3. Use the arrow buttons and the OK button to
select and save the profile.
4. Push the BACK button.
If settings have been changed but not saved, the
symbol * is shown beside the profile name.
1220 - 001 -
To change the name of a profile
1. Do steps 1–3 in
on page 23 .
Installation
2. Use the arrow buttons and the OK button to
move through the menu structure Settings
Profiles > Use profiles > Profile A, B, C. >
Rename.
3. Use the arrow buttons and the OK button to
select letters.
4. Push the BACK button to save the new
profile name.
To use a profile
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use profiles > Profile A, B, C >
Select.
Installation
3. Push the BACK button.
To connect a new charging station to a profile
1. Save the settings in a profile to be used with
the original charging station. Do steps 1–4 in
To save settings to a profile on page 29 .
2. Put the product in the new charging station.
3. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
4. Save a profile for the new charging station,
or select a profile in the list. Do steps 1–4 in
To save settings to a profile on page 29 , or
do steps 1–3 in
3.9.10.2 ECO mode
ECO mode stops the signal in the boundary loop,
the guide wire and the charging station, when the
product is parked or is charging.
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Settings >
Note: Push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To get access to the menu
To get access to the menu
To use a profile on page 29 .
ECO mode to save energy and avoid
Installation - 29
>
Settings >
Security >