Husqvarna Automower 310 Operator's Manual page 27

3.9.5.4 To do a test of the Lawn coverage
function
1. Put the product in the charging station.
To get access to the menu on
2. Do step 1-3 in
page 23 .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-3 > More > Test .
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.9.5.5 To measure the distance from the
charging station
1. Put the product in the charging station.
To get access to the menu
2. Do steps 1–3 in
on page 23 .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-3 > How far?
4. Use the number buttons to set 500 m as a
distance.
5. Push the OK button.
6. Push the BACK button.
7. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-3 > More > Test .
8. Push the OK button.
9. Push the START button and close the hatch.
10. Push the STOP button when the product is
at the distance you select to measure. The
distance shows in the display.
3.9.5.6 To disable or enable the Lawn coverage
function
Disable the Lawn coverage function for each
area.
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-3 > Disable .
3. Use the left arrow button to disable or
Lawn coverage function.
enable the
4. Push the OK button.
5. Push the BACK button.
1220 - 001 -
3.9.5.7 To reset the Lawn coverage settings
You can reset the
each area and use the factory setting.
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
Installation
move through the menu structure
> Lawn coverage > Area 1-3 > More >
Reset .
3. Use the arrow buttons to select
4. Push the OK button.
3.9.6 Methods for the product to find the
charging station
The product has 3 search methods to find the
charging station :
• Irregular - The product moves in the work
area until it finds the signal of the charging
station.
• Guide wire - The product moves in the work
Installation
area until it finds the guide wire. The product
moves along the guide wire to the charging
station.
• Boundary wire - The product moves in the
work area until it finds the boundary wire.
The product moves along the boundary wire
to the charging station.
Installation
The factory setting is set to mix the 3 search
methods. When the battery is low the product
starts to search for the charging station with the
irregular method for 3 min. After 3 min the
product changes search method to the guide wire
method. The product tries to find the guide wire
for 8 min. After 11 min the product changes
search method to the boundary wire method.
You can change the settings for how the product
finds the charging station to adapt to the work
area.
3.9.6.1 To set how the product finds the charging
station
You can make manual settings to make the
product search for the guide wire or the boundary
Installation wire in 0–30 min from when the battery is low.
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Lawn coverage settings for
To get access to the menu
Installation
Reset .
To get access to the menu
Installation
Installation - 27