Symbols On The Product - Husqvarna AUTOMOWER 435X AWD Operator's Manual

16. Charging station
17. Power supply (the appearance of the power
supply may differ depending on market)
18. Low voltage cable
19. Alarm decal
20. Extra blades
21. Cable markers
22. Operator's Manual and Quick Guide
23. Measurement gauge for help when installing
the boundary wire (the measurement gauge
is broken loose from the box)
24. Screws for securing the charging station
25. Loop wire for boundary loop and guide wire
1
26. Couplers for loop wire
3
27. Stakes
28. Connector for the loop wire

1.4 Symbols on the product

These symbols can be found on the product.
Study them carefully.
1
Is a part of the Installation kit which is purchased separately.
2
Refer to note 1
3
Refer to note 1
4
Refer to note 1
1035 - 001 - 04.02.2019
2
4
WARNING: Read the
user instructions before
operating the product.
WARNING: Operate the
disabling device before
working on or lifting the
machine.
The product can only start
when the correct PIN
code has been entered.
Switch off the product be-
fore carrying out any in-
spections and/or mainte-
nance.
WARNING: Keep a safe
distance from the ma-
chine when operating.
Keep your hands and feet
away from the rotating
blades.
WARNING: Do not ride
on the machine. Never
put your hands or feet
close to or under the ma-
chine.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 52 and on the
rating plate.
Introduction - 5