Symbols On The Product; Symbols On The Battery; Symbols In The App - Husqvarna CEORA Operator's Manual

LED indicator light Product status
Pulsates white The product sets to OFF.
Firmware installation is in progress.
Flashes white New firmware must be installed.
There is more information on www.husqvarna.com. Speak to your approved servicing dealer for more information.

2.10 Symbols on the product

These symbols can be found on the product. Make sure
that you understand them.
WARNING: Read the opera-
tor instructions before you op-
erate the product.
WARNING: Disable the prod-
uct before maintenance or
before you lift the product.
WARNING: Keep a safe dis-
tance from the product when
it is in operation. Keep your
hands and feet away from the
rotating blades of the product.
WARNING: Do not sit on
the product. Do not put your
hands or feet near or below
the product.
Use a detachable power sup-
ply as specified on the rating
plate adjacent to the symbol.
This product complies with the applicable
EU Directives.
This product complies with the applicable
UK Directives.
It is not permitted to dispose the product
as usual domestic waste. Obey national
regulations and use the local recycling
system.
1691 - 006 - 09.01.2023
The chassis contains components which
are sensitive to electrostatic discharge
(ESD). The chassis must only be opened
and sealed by an authorized service
technician. The warranty will not be
applicable if the seal is broken.
Note:
Other symbols/decals on the product refer to
certification requirements for some markets.

2.11 Symbols on the battery

WARNING: Lithium-ion batteries can
explode or cause fire if disassembled,
short-circuited or handled roughly. Do not
expose to water, fire or high temperature.
Read the user instructions.
Do not discard the battery into fire and do
not expose the battery to a heat source.
Do not immerse the battery into water.

2.12 Symbols in the app

Shows the strength of the radio signal that
the product receives from the reference
station.
The status is EPOS confirmed . The
product has an accurate position and
direction. This is necessary to operate
the product automatically and for the
installation of map objects.
Introduction - 11