Husqvarna Automower 310 Operator's Manual page 44

Message Cause
Next start hh:mm
The timer setting prevents the product
from operating.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
The time on the product is not correct.
The day's mowing
The rest period is in progress. The
is complete
product has an inbuilt standby period
according to the Standby time table.
Lifted
The lift sensor has been activated as
the product has become trapped.
Collision sensor
The product body can not move freely
problem, front/rear
around its chassis.
Wheel drive prob-
Grass or other object is wrapped
lem, right/left
around the drive wheel.
Alarm! Mower
The alarm was activated because the
switched off
product was switched OFF.
Alarm! Mower
The alarm was activated because the
stopped
product was stopped.
Alarm! Mower lif- The alarm was activated because the
ted
product was lifted.
Alarm! Mower til-
The alarm was activated because the
ted
product was tilted.
Electronic problem Temporary electronic or firmware rela-
ted issue.
Loop sensor prob-
lem, front/rear
Charging system
problem
Tilt sensor prob-
lem
Temporary prob-
lem
44 - Troubleshooting
Action
Change the timer settings. Refer to
set the timer on page 24 .
This behavior is normal and no action
is required.
To set the time &
Set the time. Refer to
date on page 30 .
This behavior is normal and no action
is required.
Free the product
Check that the product body can move
freely around its chassis.
If the problem remains, the message
requires action by authorized service
technician.
Clean the wheels and around the
wheels.
Adjust the security level in the
To set the security level
menu, refer to
on page 24 .
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
To
Security
1220 - 001 -