Husqvarna Automower 310 Operator's Manual page 28

> To find the charging station > Overview of
search methods > Guide .
3. Push the arrow buttons to select 1 of the
guide wires.
4. Push the number buttons to set the time.
5. Push the OK button.
6. Push the BACK button.
7. Use the arrow buttons and the OK button to
move through the menu structure
> To find the charging station > Overview of
search methods > Boundary wire .
8. Push the number buttons to set the time.
9. Push the OK button.
10. Push the START button and close the hatch.
3.9.6.2 To do a test of the guide wire
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find charging station > Guide > More >
Test guide .
3. Put the product 3 m / 9 ft. from the boundary
wire.
4. Push the START button and close the hatch.
5. Make sure the product follows the guide wire
to the charging station.
6. Make sure the product docks with the
charging station.
7. If the product does not dock with the
charging station, change the position of the
charging station or the guide wire. Refer to
To examine where to put the charging
station on page 16 and To examine where to
put the guide wire on page 19 .
3.9.6.3 To do a test of the boundary wire
1. Put the product 3 m / 9 ft. from the boundary
wire, facing the boundary wire.
To get access to the menu
2. Do steps 1–3 in
on page 23 .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Find charging station > Overview of
search methods > Boundary > More > Test
right / Test left .
4. Push the START button and close the hatch.
28 - Installation
5. Make sure the product follows the guide wire
to the charging station.
6. Make sure the product docks with the
charging station.
7. Change the position of the charging station
or the guide wire if the product does not
dock with the charging station. Refer to
examine where to put the charging station
on page 16 and To examine where to put
Installation
the guide wire on page 19 .
3.9.6.4 To change the signal range of the
charging station
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station > Overview of
search methods > Charging station range .
3. Use the left arrow button to select
MID, MIN .
Installation
4. Push the BACK button.
Note: It is usually better to move the charging
station, than to decrease the range of the
charging station signal.
3.9.7 To set the exit angles
The product moves away from the charging
station with an exit angle between 90°–270°. The
exit angles can be set to 1–2 exit sectors.
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Exit angles > Sector 1 or 2 .
3. Use the number buttons to set the angles in
degrees.
4. Push the down arrow button.
5. Use the number buttons to select how
frequently the product must use each sector.
Set in %.
6. Push the BACK button.
Installation
3.9.8 To set the reversing distance
The reversing distance is how many cm the
product reverses when it leaves the charging
station. The factory setting is 60 cm.
To
To get access to the menu
Installation
MAX,
To get access to the menu
Installation
1220 - 001 -