Service - Markusson Sensomatic Original Instruction Manual

Sensomatic
• If the test is successful, the wire does not
need to be adjusted . The test is finished .
• If the lifting arm and flange do not completely
meet or do not meet long enough, perform the
next steps .
• If the wire is damaged or worn, it must
be replaced; see section 8 .2, "List of
accessories" . When it has been replaced,
repeat steps 1-8 .
7 . Set the chain pusher switch to OFF .
8 . To set the wire so that the lifting arm meets the
flange:
• for a shorter time: turn the 2 nuts (D) in the
direction towards the machine .
• for a longer time: turn the 2 nuts (D) in the
direction from the machine .
D
9 . Repeat steps 5-8 until the test is successful .
Maintenance and Service

6 .7 Service

WARNING The user must only do maintenance
that is described in this manual on the machine .
Only approved and trained service technicians can
do service on the machine .
Contact the reseller if the machine needs to be
serviced . Pack it in its original packaging for safe
shipping .
Sensomatic 201902 EN 39