Use Skip Tooth Mode - Markusson Sensomatic Original Instruction Manual

Sensomatic
2 . Monitor the grinding wheel movements, and
check if the chain is sharpened .
3 . If required: Turn the grinding depth knob,
located on the back of the grinding head, to
make minor adjustments for the grinding depth .
4 . If required: Turn the chain pusher adjustment to
make minor adjustments for the grinding length .
5 . Set the chain pusher switch to OFF when the
grinding head is in its uppermost position and
the chain lock is not engaged .
Important! If the chain has double tie straps, start
grinding on the first cutter behind the double-link .

5 .2 .14 Use skip tooth mode

Sensomatic Auto Chain Grinder has 2 chain pusher
modes:
• The standard mode, used for sharpening
standard chains .
• The skip tooth mode, used for sharpening
3/8" pitch "standard skip sequence chains"
that have twice the distance between the
cutting teeth .
Adjust the chain pusher mode so it accurately
sharpens the type of chain you're using .
To set the machine into skip tooth mode:
1 . Use a finger or a tool to press plate B away
from plate A until it unlocks, and then move it in
the direction of the "Skip tooth" arrow .
B
2 . Use a finger to press plate B downward and
forward into the "Skip tooth" position .
B
3 . Sharpen the chain as instructed in section 5 .3,
"Operate the machine" .
To set the machine back into standard mode:
1 . Use a finger to move plate B in the direction of
the "Standard" arrow, until it enters its locked
position .
B
2 . Sharpen the chain as instructed in section 5 .3,
"Operate the machine" .
Sensomatic 201902 EN 31
Operation
A
A
A