Check And Adjust The Wire - Markusson Sensomatic Original Instruction Manual

Maintenance and Service
8 . Do a sharpening test and make sure that the
chain remains in its position during the test .
See section 7 .2, "Sharpening test" .
9 . If required: Repeat steps 3-8 until the chain is
fixed during sharpening .

6 .6 Check and adjust the wire

Note: If the wire is not correctly set, the grinding
machine will not operate correctly . The manufacturer
initially sets the wire, but it will become worn during
normal machine operations . Always make sure
that the wire is set correctly . If necessary, adjust or
replace the wire .
1 . Press the power button to turn on the machine .
2 . Set the grinding speed knob to high speed . See
section 3 .6 .2, "Grinding speed knob" .
3 . Press the grinding head positioning button to
turn the grinding head to the left .
38 Sensomatic 201902 EN
4 . Set the top-plate angle to 30° . See section
5 .2 .3, "Set the top-plate angle" .
5 . Set the chain pusher switch to ON .
6 . Place a 0 .05 mm (0 .019") feeler gauge (B)
between the lifting arm (C) and the flange (A)
and make sure that the lifting arm completely
meets the flange for about 1 .5 seconds before
it lifts again .
IMPORTANT The feeler gauge must sit
tightly between the lifting arm and the flange .
There must be no gap .
A
B
C
Sensomatic