Counter; Grinding Speed Knob; Chain Overview - Markusson Sensomatic Original Instruction Manual

Sensomatic

3 .6 .1 Counter

The counter consists of a display and buttons that set the number of cutters to be sharpened . Before you start the
machine, use the buttons to program the number of cutting teeth to be sharpened . The machine will automatically
stop after the programmed number of cutting teeth have been sharpened .
• The lower digits on the display show how many cutting teeth that will be sharpened before the machine
automatically stops . The first digit button (I) sets the first digit (1xxx-9xxx), the second button sets the second
digit (x1xx-x9xx), etc . The counter can be set to count up to 9999 sharpened cutting teeth . The number of
cutting teeth set will be stored in the memory until the next time the number is set .
• The upper digits show the number of cutting teeth that are already sharpened . This number increases by 1 for
every cutting tooth that is sharpened . This counter can be reset by using the "reset" button .

3 .6 .2 Grinding speed knob

The grinding speed knob sets the speed of the grinding wheel . The speed can be set to different speeds to grind 0 to
4 mm (0" to 5/32") off the cutting teeth .

3 .7 Chain overview

This section describes the definitions for the parts of a normal chain .
A
R
B
Pos Part
Cutters
A
Drive link
B
Tie strap
C
Cutting tooth
D
Gullet
E
Rivet hole
F
Depth gauge
G
L
C
Description
R: Right cutter . L: Left cutter .
The lower part of a link . Used to push the chain forward in the
chainsaw, etc .
The links separating the cutters .
The part of the cutter that cuts chain .
The space between the cutting tooth and the depth gauge .
A hole where the rivet is placed .
The front part of the cutter .
Product Description
A
D
E
Sensomatic 201902 EN 13
G
F