Tighten The Chain - Markusson Sensomatic Original Instruction Manual

Sensomatic
3 . Pull the chain around by hand to make sure
that it runs freely in the chain vise and does
not wobble .
CAUTION! If the chain does not run freely,
or if the chain is forced down into the groove by
pressure from the air tensioner, it can get caught
during the feed .
Adjust the groove width with the adjustment
bolts . The groove must be the same width as the
drive link, or 0 .2 mm wider .
a) Use the adjustment bolts to adjust the
width of the groove . Tighten the nuts until the
chain is fixed, then loosen them about 1/2 turn .
b) Check manually that the chain moves freely
in the vise, and that the vise is not too wide . If
necessary, repeat step a) .

5 .2 .5 Tighten the chain

Use the upper tensioner roll for short chains .
Use the lower tensioner roll for long chains .
1 . Loosen the locking handle and move the
tensioner upward or downward to make enough
room to position the chain .
2 . When using the upper tensioner roll, place the
chain below the tensioner roll .
3 . When using the lower tensioner roll, lift the
tensioner arm (there is a quick release function)
and place the chain below the tensioner roll .
4 . Lower the tensioner arm to its bottom position .
Sensomatic 201902 EN 25
Operation