Adjust The Chain Lock - Markusson Sensomatic Original Instruction Manual

Sensomatic

6 .5 Adjust the chain lock

NOTE: This instruction is for .404 chain pitch . For
other chain pitches, adjust to lower numbers . The
chain lock needs to be adjusted if the chain is not
fixed during sharpening .
1 . Lift the grinding head to its most upright
position .
CAUTION Make sure that the grinding wheel
is turned off .
2 . Set the sensor switch to OFF .
3 . Set the chain pusher switch to ON (A) . When
the chain pusher starts moving forward, the
chain vise is in its UNLOCKED position (C) . Set
the chain pusher switch to OFF (D) .
A
B
C
D
Maintenance and Service
4 . Make sure that the groove in the chain vise is
approximately 2 .2 mm . Insert the feeler gauge .
Adjust the nuts if necessary to adjust the chain
vise so the feeler gauge can slide out .
5 . Set the chain pusher switch to ON (1) . When
the chain pusher is in its rear position, the chain
vise is in its LOCKED position (2) . Set the chain
pusher switch to OFF (3) .
6 . Make sure that the groove in the chain vise is
between 0 .15 and 0 .3 mm .
7 . If the groove is not between 0 .15 and 0 .3 mm
wide, turn the nut (A) in 1
until the groove in the chain vise is between
0 .15 and 0 .3 mm .
Sensomatic 201902 EN 37
1 .5 turns clockwise,
–
A