Table of Contents
Advertisement
Operation
Grinding wheel diameter:
150 mm (5 .9")
(new grinding wheels)
140 mm (5 .5")
130 mm (5 .1")
5 .
Repeat steps 1
–
equal .
5 .2 .11 Set the grinding length
1 .
To set the approximate grinding length, turn the
chain pusher adjustment knob:
• clockwise, to grind more, resulting in a shorter
cutter top plate, or
• counter-clockwise, to grind less, resulting in a
longer cutter top plate .
5 .2 .12 Set the depth gauge height
Change the grinding setting for the height of the
depth gauges if required .
30 Sensomatic 201902 EN
Scale:
1–3
3–5
4–6
2 until the grinding depth is
1 .
Do a sharpening test on a test chain, according
to the instructions in section 7 .2, "Sharpening
test" .
2 .
Set the depth gauge according to the chain
manufacturer's recommendations . See the
attached template to make sure that the depth
gauge meets the correct specifications .
3 .
Turn the depth gauge height knob to set the
remaining depth gauges:
• clockwise to increase the height of the depth
gauge (and therefore grind less of it), or
• counter-clockwise to decrease the height of
the depth gauge (and therefore grind more
of it) .
4 .
Repeat the sharpening test until the height of
the depth gauges is correct . Use the template
provided with the machine and refer to the
top-plate angle chart to determine the correct
height .
5 .2 .13 Test the grinding settings
1 .
Set the chain pusher switch to ON . The chain
pusher arm will push the chain forward .
Sensomatic
Advertisement
Table of Contents
Troubleshooting
