Fastening The Chain Vise; Checking And Adjusting The Wire - Markusson Grindomatic V12 Original Instruction Manual

Maintenance and Service

6.4 Fastening the chain vise

The chain vise needs to be fastened if the chain is
not fixed during sharpening.
1. Turn the nut (A) in 1-1.5 turns clockwise, until
the groove in the chain vise is 0,6 - 0,8 mm
wide in locked position.
NOTE: This instruction is for .404 chain pitch.
For other chain pitches, adjust to lower numbers.
2. Do a sharpening test and make sure that the
chain remains in its position during the test.
See section 7.2, "Sharpening test".
3. If required: Repeat steps 1-2 until the chain is
fixed during sharpening.
28 Grindomatic 201708 EN
A

6.5 Checking and adjusting the wire

Note: If the wire is not correctly set, the grinding
machine will not operate correctly. The manufacturer
initially sets the wire, but it will become worn during
normal machine operations. Always make sure
that the wire is set correctly. If necessary, adjust or
replace the wire.
1. Press the power button to turn on the machine.
2. Press the grinding head positioning button to
turn the grinding head to the left.
3. Set the top-plate angle to 30°. See section 3,
"Tighten the head-tilt angle knob." for
instructions.
Grindomatic