Assembly Of The Coronastar For Angle Adapter - WAGNER PEA-C4-HiCoat Translation Of The Original Operating Manual

VERSION 05/2019
8.9

ASSEMBLY OF THE CORONASTAR FOR ANGLE ADAPTER

WARNING
Danger from electric current!
Risk of injury and damage to the device.
The conversion on the CoronaStar may only be carried out by trained personnel.
Prior to assembling the CoronaStar, the high voltage and powder feed must be
switched off and secured against being inadvertently switched on.
Procedure:
1. Switch off the high voltage and the powder feed
and secure them against being inadvertently
switched on.
2. Remove plug 1 from the gun housing.
3. Fit CoronaStar, for angle adapter 2, on the angle
adapter (direction of fitting shown is merely an
example).
4. Fasten the connection cable 3 on the gun housing.
Note:
Check whether the grounding is assured.
5. The spray gun is ready for use again.
Note:
Put stopper 1 back into hole in gun housing
when converting the gun in the normal version
without angle adapter.
ORDER NUMBER DOC390829
PEA-C4-HiCoat
1
2
3
P_01169
41