Installing The Protective Wedge - WAGNER PEA-C4-HiCoat Translation Of The Original Operating Manual

VERSION 05/2019

8.5.2 INSTALLING THE PROTECTIVE WEDGE

Note:
The same wedge tool is used to insert the protective wedge.
1 Protective wedge (when positioned)
2 Electrode holder (shown with a cut-away
view to improve comprehension)
3 Wedge tool
Procedure:
1. Guide protective wedge 1 into wedge tool 3.
2. Insert both parts into opening on electrode
holder 2 up to stop.
3. If it is not possible to push the wedge tool in
as far as the X mark, rotate the wedge tool a
little until it can be pushed up to the mark.
The mark X must be flush with the Y end of
the electrode holder.
4. The protective wedge is now correctly
assembled and the wedge tool can be pulled
out of the electrode holder.
The protective wedge remains inserted in
the electrode holder.
ORDER NUMBER DOC390829
2
P_03911
2
PEA-C4-HiCoat
3
1
Y
3
1
Y
X
P_03912
X
P_00599
35