Safety Instructions For The Personnel; Personal Safety Equipment; Safe Handling Of Wagner Powder Spray Devices - WAGNER PEA-C4-HiCoat Translation Of The Original Operating Manual

VERSION 05/2019
4.2

SAFETY INSTRUCTIONS FOR THE PERSONNEL

Always follow the information in this manual, particularly the safety instructions and
the warning instructions.
Always follow local regulations concerning accident prevention regulations.
In electrostatics applications: Persons belonging to a risk group according to
EMF guideline 2013/35/EU (e.g., carriers of active implants), must not enter the
high-voltage area.

4.2.1 PERSONAL SAFETY EQUIPMENT

Danger due to dust formation!
Serious or fatal injuries due to inhalation, swallowing or contact with the skin or eyes.
Observe the processing regulations laid down by the manufacturer of the powder
lacquer being used, when preparing or processing the powder.
Take note of the manufacturer's notification and the relevant environmental protection
regulations when disposing of powder lacquers.
Take the specified protective measures. In particular, wear safety goggles, protective
clothing and gloves, as well as hand protection cream if necessary.
Use a mask or breathing apparatus if necessary.
For sufficient health and environmental safety: Operate the device in a powder coating
booth or on a spraying wall with the ventilation (extraction) switched on.

4.2.2 SAFE HANDLING OF WAGNER POWDER SPRAY DEVICES

Danger due to dust formation!
Do not point spray guns at people.
Do not spray device parts using electrostatic equipment.
Before any work on the device, in the event of work interruptions and malfunctions:
– Switch off the energy/compressed air supply.
– Relieve pressure on powder spray gun and device.
– Secure the powder spray gun against actuation.
– Disconnect the control unit from the mains.
– In the event of functional faults: remedy the fault as described in the
"Troubleshooting" chapter.
ORDER NUMBER DOC390829
PEA-C4-HiCoat
13