Cleaning And Maintenance; Cleaning; Cleaning Personnel; Cleaning Procedures - WAGNER PEA-C4-HiCoat Translation Of The Original Operating Manual

VERSION 05/2019
8

CLEANING AND MAINTENANCE

8.1

CLEANING

8.1.1 CLEANING PERSONNEL

Cleaning work should be undertaken regularly and carefully by qualified and trained personnel.
They should be informed of specific hazards during their training.
The following hazards may arise during cleaning work:
– health hazard from inhaling powder lacquer,
– use of unsuitable cleaning tools and aids.

8.1.2 CLEANING PROCEDURES

The cleaning intervals should be adapted by the operator depending on the level of use and
if necessary the level of soiling.
If in doubt, we recommend contacting WAGNER's specialist personnel.

8.1.3 PERFORMING A PAINT CHANGE

WARNING
Dust formation!
Risk of poisoning if inhaled.
Danger due to escaping dust, contamination of the device and device components.
Before starting cleaning or other manual work, the high voltage must be shut down
and locked to prevent it from being switched back on!
During every paint change, the extraction system of the booth and the filter cleaning
system must remain switched on!
In the case of a paint change, powder residues must be thoroughly removed from all powder
feeding parts. In the following, only the procedure for the powder spray gun is described.
Note:
During a paint change, the nozzle system does not necessarily have to disassembled.
If the union nut is not screwed on tightly up to the stop position, this may cause the paint
to smear.
Procedure:
1. Automatically flush powder coating system, switch it off and secure it from being
switched back on.
2. If no automatic flushing takes place, manually flush the automatic gun and remove
any powder residue before the powder coating system is switched off.
– Disconnect the powder feed hose from the automatic gun.
– Blow through the automatic gun using an air gun and thus remove any powder residues.
– Switch off powder coating system and secure it from being switched back on.
3. After cleaning all powder feeding parts, reconnect the powder feed hose to the
automatic gun.
4. The automatic gun is ready for use again.
ORDER NUMBER DOC390829
PEA-C4-HiCoat
29