Replacing The Wearing Parts - WAGNER PEA-C4-HiCoat Translation Of The Original Operating Manual

VERSION 05/2019

8.7.3 REPLACING THE WEARING PARTS

Procedure:
1. Loosen threaded sleeve 6 and separate angle
adapter 5 from gun body 7.
2. Loosen union nut 1.
3. Pull out electrode holder 3, together with
nozzle 2, from nozzle insert 4.
Note:
Do not damage the electrode holder, when
pulling it out and inserting it.
4. Unscrew threaded sleeve 8 and locking sleeve 9
with mounting tool 10.
5. Pull connecting element 11 out of elbow
fitting 12.
6. Insert screwdriver into recess X and turn it until
the nozzle insert 13 loosens.
7. Pull out nozzle insert 13.
8. Replace the wearing parts with new components.
9. Clean all components thoroughly and remove
any powder residues.
10. Install nozzle insert 13, as shown in the magnified
figures Y1 and Y2, in such a way that the pin B1 is
guided into the hole A1.
11. Install connecting element 11 within the
elbow fitting 12, as shown in the magnified
figure Z, in such a way that the pin B2 is guided
into the hole A2.
12. Screw threaded sleeve 8 and locking sleeve 9
with mounting tool 10 and tighten them well.
Ensure that it is still possible to turn threaded
sleeve 8 easily.
13. Install electrode holder 3 together with nozzle 2
in the nozzle insert 13.
14. Put on union nut 1 and tighten it well.
15. Mount the angle adapter to the gun again.
ORDER NUMBER DOC390829
7
P_03916
PEA-C4-HiCoat
1
2
3
4
6
5
A1
13
A2
B1
12
11
B2
Z
Y1
Y2
X
8, 9
10
P_03917
39