Assembly Of The Coronastar - WAGNER PEA-C4-HiCoat Translation Of The Original Operating Manual

VERSION 05/2019
8.8

ASSEMBLY OF THE CORONASTAR

The CoronaStar is a retrofit set for automatic guns for achieving even better surface quality
(reduces the orange peel effect).
WARNING
Danger from electric current!
Risk of injury and damage to the device.
The conversion on the CoronaStar may only be carried out by trained personnel.
Prior to assembling the CoronaStar, the high voltage and powder feed must be
switched off and secured against being inadvertently switched on.
Procedure:
1. Switch off the high voltage and the powder feed
and secure them against being inadvertently
switched on.
2. Unscrew the standard nut 1 from the gun
housing 2.
3. Screw the new nut 3 for the CoronaStar 4 onto
the gun housing and tighten well.
4. Fasten the cable guide 5 onto the cover plate 7
using screw 6.
5. Slide the CoronaStar 4 onto the gun housing 2.
Note:
Check whether the grounding is assured.
6. The spray gun is ready for use again.
ORDER NUMBER DOC390829
PEA-C4-HiCoat
1 2
3
4 5 6 7
P_03918
40