Changing From Flat Jet Nozzle To Round Jet Nozzle - WAGNER PEA-C4-HiCoat Translation Of The Original Operating Manual

VERSION 05/2019
5. After long periods of operation or having
replaced the protective wedge repeatedly, it
is also recommended to check the powder
tube for wear and replace if necessary.
You will find the necessary spare parts and
wearing parts in Chapter
operating manual.
6. Prior to re-fitting, check whether the contact
points on electrode holder 3 and in gun
housing 4 have been thoroughly cleaned
so that the electrode tip is electrically
connected to the high-voltage generator.
7. Carefully fit electrode holder 3 in gun
housing 4.
8. Slide the flat jet nozzle 2 back over
electrode holder 3 and fasten in place using
union nut 1.
8.6

CHANGING FROM FLAT JET NOZZLE TO ROUND JET NOZZLE

The standard Corona automatic gun is delivered with a flat jet nozzle. The nozzle can be
changed easily, as described below.
Note:
If changing from the flat jet nozzle to the deflector cone, the depth control must be adjusted.
The C4 R electrode holder is necessary to perform the change.
CAUTION
Electrode tip!
Risk of injury and damage to the device.
Take care when fitting the C4 R electrode holder.
ORDER NUMBER DOC390829
1
13 of this
PEA-C4-HiCoat
3
2
P_03913
4
36