Saab 9-5 2011 Owner's Manual page 221

220 Vehicle care
8. Remove the valve cap from the
valve cap stem. Activate the
TPMS sensor by increasing or de‐
creasing the tire's air pressure for
five seconds, or until a horn chirp
sounds. The horn chirp, which
may take up to 30 seconds to
sound, confirms that the sensor
identification code has been
matched to this tire and wheel po‐
sition.
9. Proceed to the passenger side
front tire, and repeat the proce‐
dure in step 8.
10. Proceed to the passenger side
rear tire, and repeat the procedure
in step 8.
11. Proceed to the driver side rear
tire, and repeat the procedure in
step 8. The horn sounds twice to
indicate the sensor identification
code has been matched to the
driver side rear tire, and the TPMS
sensor matching process is no
longer active. Tire Learning
Active in the Driver Information
Center goes out.
12. Turn the ignition off.
13. Set all four tires to the recommen‐
ded air pressure level as indicated
on the tire-loading information la‐
bel.
14. Put the valve caps back on the
valve stems.
Removing a tire
Remove the tire with a tire machine.
It is important to follow the instruc‐
tions for the tire machine.
■ Do not fit the tire tool in an area
+/- 10° from the valve.
■ Start removing opposite the valve.
■ Remove the rear side first.
Fitting a tire
Fit the tire with a tire machine. It is im‐
portant to follow the instructions for
the tire machine.
■ Start to fit about 20° after the valve.
■ Finish fitting before an area 20°
from the valve.
■ Do not inflate the tire to a pressure
higher than 102 psi.