Equipment As Still Images - Sony PCS-1/1P Operating Instructions Manual

Sending Motion Pictures Input from an External Camera or Other

Equipment as Still Images

During communication a motion picture output from an external camera or
VCR connected to the Communication Terminal can be frozen, and then sent
to the remote party.
External camera, VCR, etc.
to video output
To send a still image
1
Open the Still Image menu.
Press the MENU button on the Remote Commander to display the Setup menu,
then select the
2
Display the picture you want to send on the monitor screen.
Press the VIDEO INPUT SELECT button on the Remote Commander to
display the Video Input Select menu, then select the input from which you want
to send a picture under "Near", and press the PUSH ENTER button.
AUX 1: Selects the picture input from equipment connected to the VIDEO IN
AUX 1 connector.
AUX 2: Selects the picture input from equipment connected to the VIDEO IN
AUX 2 connector.
Notes
• Selecting "Object" enables you to display the picture input from the optional
PCS-DS150/DS150P Document Stand on the monitor screen.
• If you change the label of the video input using the Custom Input Label menu in
Page 4 of the General Setup menu, the labeled name is displayed instead of
"AUX1", "AUX2" or "Object".
3
Use the V, v, B or b button on the Remote Commander to select "Send",
then press the PUSH ENTER button.
The motion picture on the monitor screen freezes, and a still picture is sent to
the remote party. The still picture remains even after sending.
To cancel the still image display on the answering site
Select "Clear", or switch the input picture.
to S-video
output
S-video connecting cable (not supplied)
Video connecting cable (not supplied)
(still image) icon with the V or v button.
AUDIO OUT AUX1– VIDEO IN –AUX2 AUDIO IN
(MIXED)
VIDEO OUT
AUX MAIN– MONITOR– SUB
RGB OUT
to VIDEO IN
to VIDEO IN
AUX1
AUX2
Sending Motion Pictures as Still Images
CAMERA UNIT MIC XXXX WHITE
(PLUG IN POWER)
BOARD
1 2
100BASE-TX DC 19.5V
10BASE-T
XXXXXX
IR OUT
1 2
109