Using The Cascade Connection Via Lan (Up To 10 Points) - Sony PCS-1/1P Operating Instructions Manual

Using the Cascade Connection via LAN (Up to 10 Points)

Installing the optional PCS-323M1 H.323MCU software in two
Communication Terminals enables cascade connection, allowing you to
conduct a multipoint videoconference among up to ten points.
PCS-323M1
H.323 MCU
software
TERMINAL
AUDIO OUT AUX1– VIDEO IN –AUX2 AUDIO IN CAMERA UNIT
(MIXED)
VIDEO OUT
AUX MAIN– MONITOR– SUB
RGB OUT
IR OUT
1
to 100BASE-TX/
10BASE-T
Notes
• Installing the PCS-323M1 H.323 MCU software into three or more Communication
Terminals does not allow cascade connection. Note that the third or later terminals
should set "Multipoint Mode" to "Auto" in the Multipoint Setup menu or in the Setup
menu.
• For cascade connection, the "Split" and "Split (Fixed)" modes are not available. Only
the "Voice Activate" mode is available.
to LAN
VISCA OUT
MIC
(PLUG IN POWER) ISDN UNIT WHITE
1 2
BOARD
100BASE-TX DC 19.5V
10BASE-T
DSB
2
UTP cable (category 5,
straight) (not supplied)
Connection Examples for a Multipoint Videoconference
PCS-323M1 H.323
MCU software
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
LAN
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
ON LINE POWER LAN ALERT
LAN
155