Download  Print this page

Using The Display Control; What Is "broadcast Mode - Sony PCS-1/1P Operating Instructions Manual

Video communication system.
Hide thumbs

Advertisement

Using the Display Control

During a multipoint videoconference with the MCU software installed in the
communication Terminal you can control the following operations.

What is "Broadcast Mode"?

You can use the "Split", "Split (Fixed)", "Voice Activate" and "Broadcast"
modes.
Split mode
This mode allows display of the pictures from the connected remote terminals
and the picture of the local terminal by splitting the monitor screen.
According to the connected terminals, four-split windows (1 to 3 terminals
connected) or six-split windows (4 and 5 terminals connected) are displayed.
Pictures A to C (or A to E) appear in order of connecting.
Four-split window
Picture A
Picture B
Picture on the local
Picture C
site
Notes
• When the six-split window is displayed, the System detects the terminal including the
loudest sound among all the terminals and displays the picture of that terminal in the
lower right window. The picture on the local site is then displayed in the window
where the picture of the detected terminal was displayed.
• If you switch the broadcast mode from Split mode to Voice Activate mode in which
a picture of a specified terminal is shown in full screen during communication, the
location of Pictures A to E will be changed when the Split mode is restored.
• When your system is in the Split or Split (Fixed) mode, you cannot control the camera
on any connected remote terminals.
Six-split window
Picture A
Picture D
Picture E
Using the Display Control
Picture B
Picture C
Picture on the local site
173

Advertisement

Table of Contents

   Also See for Sony PCS-1/1P

This manual is also suitable for:

Pcs-1Pcs-1p

Comments to this Manuals

Symbols: 0
Latest comments: