Conducting A Data Conference Using Netmeeting - T.120 Data Conference - Sony PCS-1/1P Operating Instructions Manual

Conducting a Data Conference Using
NetMeeting – T.120 Data Conference
Connecting the Communication Terminal to the computer with NetMeeting*
installed enables conduct of a data conference in compliance with the T.120
standard of the ITU-T Recommendation via the PCS-1/1P Video
Communication System only when it is connected over ISDN.
*
NetMeeting is a registered trademark of Microsoft Corporation.
Notes
• When the Communication Terminal is used for a multipoint videoconference, the
T.120 data conference is not available.
• When the PCS-1/1P Video Communication System is connected with a
videoconferencing system at the remote party via LAN, conduct the T.120 data
conference without using the PCS-1/1P.
To connect a computer
To connect a computer to the connector on the Communication
Terminal
Use a commercially available UTP cross cable (category 5) to connect the
LAN connector on the computer with the 100BASE-TX/10BASE-T connector
on the Communication Terminal.
TERMINAL VISCA OUT
AUDIO OUT VIDEO IN AUDIO IN CAMERA UNIT
AUX1– –AUX2
(MIXED)
VIDEO OUT 100BASE-TX
AUX MAIN– MONITOR– SUB 10BASE-T
RGB OUT
IR OUT
1 2
to 100BASE-TX/
10BASE-T
UTP cross cable
(not supplied)
to LAN
connector
Computer
128
Conducting a Data Conference Using NetMeeting – T.120 Data Conference
MIC
(PLUG IN POWER) ISDN UNIT WHITE
1 2
BOARD
DC 19.5V
PCS-B768
DSB
ISDN Unit
to 100BASE-TX/
UTP cross cable
ISDN
TERMINAL VISCA OUT
AUDIO OUT VIDEO IN AUDIO IN CAMERA UNIT MIC
AUX1– –AUX2
(PLUG IN POWER) ISDN UNIT WHITE
1 2
BOARD
(MIXED)
VIDEO OUT 100BASE-TX DC 19.5V
AUX MAIN– MONITOR– SUB 10BASE-T
RGB OUT DSB
IR OUT
1 2
10BASE-T
(not supplied)
to LAN
connector
Computer