Mitsubishi Electric MELSEC iQ-R Series User Manual page 121

Section 6 SETTING AND PROCEDURE FOR OPERATION
6.4.3 Auto Refresh
This function transfers data in the buffer memory to specified devices.
Programming of reading/writing data is unnecessary.
(1) Setting procedure
Below diagrams are examples of setting the RE81WH as "Mounting slot No.: 0", "Start I/O No.: 0000".
The start I/O No. varies depending on the mounting slot No.
(a) Open the "Parameter editor".
Double-click "Parameter" → "Module Information" → "n:RE81WH" in "Navigation" window and
"Module Parameter" is opened.
(The "n" is start I/O No. of target module.)
(b) Select the [Setting value] in [Setting Item List].
(c) Double-click the item to set. And select from pull-down list or input from text box the setting value.
Supplement
Available devices are X, Y, M, L, B, T, C, ST, D, W, R, and ZR.
When a bit device X, Y, M, L, or B is used, set a number that is divisible by 32 points (example: X20,
Y120, M32).
Data in the buffer memory are stored in 32 points of devices starting from the set device No.
(Example: When X10 is set, the Data is stored in X10 to X2F).
120
RE81WH