Table of Contents
Advertisement
EventSpot 1600 Q4
Control Panel
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the back side of the device allows you to assign the DMX fixture address, which is
the first channel from which the EventSpot will respond to the controller. Please note when you use the
controller, the unit has up to 10 channels.
When using multiple EventSpots, make sure you set the DMX addresses right. Therefore, the DMX address
of the first EventSpot should be 1(001); the DMX address of the second EventSpot should be 1+10=11
(011); the DMX address of the third EventSpot should be 11+10=21 (021), etc. Please, be sure that you
don't have any overlapping channels in order to control each EventSpot correctly. If two or more
EventSpots are addressed similarly, they will work similarly.
Controlling: After having addressed all EventSpots, you may now start operating these via your lighting
controller.
Note: After switching on, the EventSpot will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX-input, the problem may be:
●
The XLR cable from the controller is not connected with the input of the EventSpot.
●
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It's necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 60 seconds
When no button is pressed for 60 seconds, the display will turn off.
To light up the display, you have to press the MODE, SET, UP or DOWN button.
Once you have pressed the button, the display will light up.
Ordercode: 44051
A)
OLED display
B)
IR-remote sensor
C)
W-DMX LED indicator
D)
MODE button
E)
UP button
F)
SET button
G)
Power button on/off
H)
W-DMX button
I)
DOWN button
Fig.09
17
Advertisement
Table of Contents
