Table of Contents
Advertisement
Infinity iB-5R
Control Panel
Fig. 04
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Infinity will respond to the controller.
Please note when you use the controller, the unit has 18 channels.
When using multiple Infinity's, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Infinity's should be 1(001); the DMX address of the second Infinity
should be 1+18=19 (019); the DMX address of the third Infinity should be 19+18=37 (037), etc.
Please, be sure that you don't have any overlapping channels in order to control each Infinity correctly.
If two or more Infinity's are addressed similarly, they will work similarly.
Controlling:
After having addressed all Infinity fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Infinity will automatically detect whether DMX 512 data is received or not. If
there is no data received at the DMX-input, the "LED" on the control panel will not flash.
The problem may be:
● The XLR cable from the controller is not connected with the input of the Infinity.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires
are swapped in the input connector.
Note: It's necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Ordercode: 41530
A)
Home button
B)
Edit Menu button
C)
Settings Mode Button
D)
Address Setting Button
E)
Infinity Logo Button
F)
Up Button
G)
Down Button
H)
OK/ENTER
I)
Left Button
J)
Right Button
K)
LCD Display
12
Advertisement
Table of Contents
