Control Panel; Dmx Addressing - SHOWTEC Stage Blinder 1 LED Manual

Stage Blinder 1 LED
The Stage Blinder 1 LED can be operated with or without a controller.

Control Panel

DMX Addressing

The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. When you select the DMX address and save it,
the controller will display the saved DMX address the next time.
The control panel on the back side of the device allows you to assign the fixture a DMX address, which is
the first channel from which the Stage Blinder will respond to the controller.
Please note when you use a controller, the unit has 2 channels.
When using multiple Stage Blinders, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Stage Blinder should be 1 (001); the DMX address of the second
Stage Blinder should be 1+2=3 (003); the DMX address of the third Stage Blinder should be 3+2=5 (005),
etc. Make sure that you do not have any overlapping channels in order to control each Stage Blinder
individually. If two or more Stage Blinders are addressed similarly, they will work similarly.
Controlling:
After having addressed all Stage Blinder fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Stage Blinder will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX input, the problem may be:
● The XLR cable from the controller is not connected with the input of the Stage Blinder.
● The controller is switched off or defective, the cable or connector is defective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 30 seconds
The display turns off after 30 seconds of inactivity. See 6. Back Light on page 15 for further information.
Press the MENU button on the control panel to light up the display.
Order code: 30784
A) MENU button
B) UP button
C) DOWN button
D) ENTER button
E) OLED display
Fig. 03
11