Table of Contents
Advertisement
EventSpot 1600 Q4
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, follow the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out the following steps.
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas: the battery, the LEDs, the internal fuse.
01) Battery. Check if the battery is fully charged.
02) The LEDs. Return the
03) The internal fuse. Return the
04) If all of the above appears to be in order, switch the unit on again.
05) If you are unable to determine the cause of the problem, do not open the EventSpot 1600 Q4, as this
may damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
No Response to DMX
Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card
malfunction.
01) Check the DMX setting. Make sure that DMX addresses are correct.
02) Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03) Determine whether the controller or light effect is to blame. Does the controller operate properly with
other DMX products? If not, take the controller in for repair. If it does, take the DMX cable and the
light effect to a qualified technician.
Ordercode: 44051
EventSpot 1600 Q4
to your Showtec dealer.
EventSpot 1600 Q4
to your Showtec dealer.
30
Advertisement
Table of Contents
